From: Khurram Khani (ajmal@xxxxxxxxxxxxxxx)
Date: Sun Feb 27 2000 - 01:38:44 GMT-3
With ILMI you register your NSAP Address with Switch. You need to an ATM
Static Route on your LS1010 with instruction 'atm route ...". Also make
sure
about this with "show atm route" that the route appears.
Khurram.
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> zhencai
> Sent: Friday, February 25, 2000 11:09 PM
> To: ccielab@groupstudy.com
> Subject: ATM SVC
> Importance: High
>
>
> Hi,
>
> I'm trying to configure ATM SVC without ilmi, I use the example from CCO:
> http://www.cisco.com/warp/public/121/13.html
> but for some reason, two routers can't ping each other. If I change to SVC
> with ilmi and use esi address, it works. Anyone had the same problem
before?
> Here is how I get NASP prefix: enable ilmi, show atm ilmi-status,
> copy&paste, disable ilmi. Is this the problem?
> Thanks a lot.
>
> Zhen Cai
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:22:54 GMT-3