RE: casscade reverse telnet?

From: Brad Hedlund (BHedlund@xxxxxxxxxxxxxxxxxxx)
Date: Thu Feb 24 2000 - 01:05:32 GMT-3

• Next message: Li Chaoyong: "Re: Can console port be used to reverse telent?"
• Previous message: Vijaykrishna: "Re: ATM SVC"
• Maybe in reply to: Michael Law: "casscade reverse telnet?"
• Next in thread: Pablo.Mosiul@xxxxxxxxxx: "Re: casscade reverse telnet?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
   Mike-
   
   Change the escape sequence on R1.
   This can be done with the 'escape-character' command under R1's vty
   lines.
   
   For example, I would configure R1 such that its escape sequence is
   CTRL-SHIFT-W X.
   
   Therefore, at R3 if I hit CTRL-SHIFT-6 X, I would come back to R2 and
   not R1.
   
   Regards,
   
   Brad Hedlund
   CCIE #5530
   
   -----Original Message-----
   From: Michael Law [mailto:htluo@cisco.com]
   Sent: Wednesday, February 23, 2000 7:05 PM
   To: CCIE Lab
   Subject: casscade reverse telnet?
   
   I telnet from R1's AUX port to R2's CON port, and then telnet from
   R2's AUX port to R3's CON port.
   
   Now, I press CTRL-SHIFT-6, I go back to R1.
   
   Is there any way I can get back from R3 to R2, not the R1?
   
   
   
   Michael

• Next message: Li Chaoyong: "Re: Can console port be used to reverse telent?"
• Previous message: Vijaykrishna: "Re: ATM SVC"
• Maybe in reply to: Michael Law: "casscade reverse telnet?"
• Next in thread: Pablo.Mosiul@xxxxxxxxxx: "Re: casscade reverse telnet?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:22:54 GMT-3