From: zhencai (zhencai@xxxxxxxx)
Date: Tue Feb 22 2000 - 04:44:31 GMT-3
Earl,
Thanks for answering my question. After configuring the two PVCs (qsaal and
ilmi), how do I determine the NSAP address? "show lane default"?
Thanks again.
Zhen Cai
-----Original Message-----
From: Earl Aboytes [mailto:earl@linkline.com]
Sent: Monday, February 21, 2000 11:23 PM
To: ccielab@groupstudy.com; zhencai
Subject: Re: ATM SVC
When speaking about a lab situation you will either be given the NSAP
address or it will be assigned to your device by signalling to the ATM
switch. You will need to configure two PVCs.
atm pvc 1 0 16 ilmi
atm pvc 2 0 5 qsaal
These two commands will allow your device to signal to the LS1010 and allow
it to pick up an NSAP address.
Earl
---------- Original Message ----------------------------------
From: "zhencai" <zhencai@home.com>
Reply-To: "zhencai" <zhencai@home.com>
Date: Mon, 21 Feb 2000 20:57:23 -0800
>Hi,
>
>When configuring ATM SVC, where do I get the NSAP address? It's not
randomly
>picked, is it?
>Thanks a lot.
>
>Zhen Cai
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:22:54 GMT-3