From: Naushad Prasla (naushad.prasla@xxxxxxxxx)
Date: Fri Dec 24 1999 - 18:54:53 GMT-3
Vijay,
I found the enclosed Cisco response on one of the newsgroup posting. I could
not get this to work either. I assume the Cisco response also include
"Routes" but he only talks about SAPs.
Question, does Cisco support multiple NLSP areas? If yes, beginning what IOS
release?
Naushad Prasla
************************************************************
NLSP is a link-state protocol. You can only do SAP filtering between areas
(last time I looked we only supported a single area though).
With NLSP enabled, any SAP filtering will have to be done down on your
server.
Wade
---------------------------------------------------------------------------
Wade Williams "Put your message in a modem, and throw
Systems Engineer, CCIE #3373 it in the cyber sea."
Cisco Systems, Inc. - N. Peart
Brentwood, TN
615-221-2918
wwilliam@cisco.com
*************************************************************
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Vijay A
Sent: Thursday, December 23, 1999 1:27 PM
To: ccielab@groupstudy.com
Subject: NLSP route filter
Hi all,
I tried distribute-list in & out; output and input network filter to block
the NLSP route update but nothing worked... is there any trick to filter the
NLSP routes ?
thanks,
-vj
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:22:00 GMT-3