From: Mike McSpedon (Mike@xxxxxxxx)
Date: Thu Dec 23 1999 - 13:15:16 GMT-3
Thanks for the clarification.
-Mike
At 03:59 PM 12/23/99 -0000, Derek Fage wrote:
>This example looks like a dialer interface that uses rotary groups. This is
>Legacy DDR (uses dialer maps).
>
>I'm fairly sure Chad is correct in that if you use the newer dialer profiles
>(dialer pool etc...) you cannot do snapshot routing.
>
>Derek...
>
>> -----Original Message-----
>> From: Mike McSpedon [SMTP:Mike@ccci.com]
>> Sent: 23 December 1999 15:16
>> To: Chad Marsh; Curtis Phillips
>> Cc: ccielab@groupstudy.com
>> Subject: Re: Snapshot routing on dialer interfaces?
>>
>> Chad,
>>
>> I was able to get it to work just fine last night for IP, IPX, and AT
>> using
>> dialer interfaces on the hub router using 2500s and 11.3(5). FWIW, there
>> is a Tech Tip on CCO at http://www.cisco.com/warp/public/129/21.html that
>> shows the server configured on a dialer interface. Is there, perhaps, an
>> IOS bug in one of the code levels that causes Snapshot routing not to work
>> with logical interfaces?
>>
>> Just thought I'd add my .02...
>>
>> -Mike
>>
>>
>> At 05:42 PM 12/21/99 -0800, Chad Marsh wrote:
>> >You can do snapshot routing on dialer interfaces if you use rotory
>> >groups, it will not work with dialer pools.
>> >
>> >Chad Marsh
>> >CCIE# 5185
>> >
>> >Curtis Phillips wrote:
>> >>
>> >> Hello,
>> >>
>> >> I was curious to find Caslow's example of snapshot routing in his book
>> >> to reference legacy (physical) interface configuration for snapshot
>> routing.
>> >> Is it workable to perform config on Dialer interface instead?
>> >>
>> >> I have a had little luck.
>> >>
>> >> Please advise and send config if possible..
>> >>
>> >> Regards,
>> >>
>> >> Curtis
>> >>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:22:00 GMT-3