From: Derek Fage (DerekF@xxxxxxxxxxx)
Date: Thu Dec 23 1999 - 12:59:42 GMT-3
This example looks like a dialer interface that uses rotary groups. This is
Legacy DDR (uses dialer maps).
I'm fairly sure Chad is correct in that if you use the newer dialer profiles
(dialer pool etc...) you cannot do snapshot routing.
Derek...
> -----Original Message-----
> From: Mike McSpedon [SMTP:Mike@ccci.com]
> Sent: 23 December 1999 15:16
> To: Chad Marsh; Curtis Phillips
> Cc: ccielab@groupstudy.com
> Subject: Re: Snapshot routing on dialer interfaces?
>
> Chad,
>
> I was able to get it to work just fine last night for IP, IPX, and AT
> using
> dialer interfaces on the hub router using 2500s and 11.3(5). FWIW, there
> is a Tech Tip on CCO at http://www.cisco.com/warp/public/129/21.html that
> shows the server configured on a dialer interface. Is there, perhaps, an
> IOS bug in one of the code levels that causes Snapshot routing not to work
> with logical interfaces?
>
> Just thought I'd add my .02...
>
> -Mike
>
>
> At 05:42 PM 12/21/99 -0800, Chad Marsh wrote:
> >You can do snapshot routing on dialer interfaces if you use rotory
> >groups, it will not work with dialer pools.
> >
> >Chad Marsh
> >CCIE# 5185
> >
> >Curtis Phillips wrote:
> >>
> >> Hello,
> >>
> >> I was curious to find Caslow's example of snapshot routing in his book
> >> to reference legacy (physical) interface configuration for snapshot
> routing.
> >> Is it workable to perform config on Dialer interface instead?
> >>
> >> I have a had little luck.
> >>
> >> Please advise and send config if possible..
> >>
> >> Regards,
> >>
> >> Curtis
> >>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:22:00 GMT-3