From: Jason Chen (jchenk@xxxxxxxxxxxx)
Date: Sun Dec 05 1999 - 02:05:09 GMT-3
Hi, Prasla,
how to config the lecs's atm address in les& lec manually?
which command i can use?
Thanks in advance.
Best Regards
Jason Chen
On Sat, 04 Dec 1999 12:05:26 -0600
Naushad Prasla <naushad.prasla@sabre.com> wrote:
> Jason,
>
> LECS can be setup on LS1010 but not necessarily. You may also choose to
> setup LECS on ATM adapter in your router by manually assigning LECS NSAP
> address (I believe you would want to do it on a sub-interface). However, all
> other ATM connections much also know this LECS NSAP address because it it
> not automatically learned via ILMI. Therefore, you would have to manually
> configure all participating ATM adapters for this LECS address.
>
> Any other comments on this one?
>
> Naushad Prasla
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of Jason
> Chen
> Sent: Saturday, December 04, 1999 7:58 AM
> To: ccielab@groupstudy.com
> Subject: ATM lane
>
>
> hi, all
>
> When config the lane in the lab,
> Is it necessary setting the lecs nsap address in ls1010? if necessary, in
> the
> lab, I can't enter the ls1010, how can i know the lecs nsap address?
>
> TIA
> JASON CHEN
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:58 GMT-3