From: Michael Bausenwein (mikeb55@xxxxxxxx)
Date: Sun Dec 05 1999 - 13:27:42 GMT-3
You do it in the lane config-atm-address NSAP-Address of the LECS. You get
the LECS |NSAP from show lane default on the lecs.
----- Original Message -----
From: Jason Chen <jchenk@online.sh.cn>
To: Naushad Prasla <naushad.prasla@sabre.com>
Cc: <ccielab@groupstudy.com>
Sent: Sunday, December 05, 1999 12:05 AM
Subject: Re: ATM lane
> Hi, Prasla,
> how to config the lecs's atm address in les& lec manually?
> which command i can use?
> Thanks in advance.
> Best Regards
> Jason Chen
>
> On Sat, 04 Dec 1999 12:05:26 -0600
> Naushad Prasla <naushad.prasla@sabre.com> wrote:
>
> > Jason,
> >
> > LECS can be setup on LS1010 but not necessarily. You may also choose to
> > setup LECS on ATM adapter in your router by manually assigning LECS NSAP
> > address (I believe you would want to do it on a sub-interface). However,
all
> > other ATM connections much also know this LECS NSAP address because it
it
> > not automatically learned via ILMI. Therefore, you would have to
manually
> > configure all participating ATM adapters for this LECS address.
> >
> > Any other comments on this one?
> >
> > Naushad Prasla
> >
> >
> > -----Original Message-----
> > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Jason
> > Chen
> > Sent: Saturday, December 04, 1999 7:58 AM
> > To: ccielab@groupstudy.com
> > Subject: ATM lane
> >
> >
> > hi, all
> >
> > When config the lane in the lab,
> > Is it necessary setting the lecs nsap address in ls1010? if necessary,
in
> > the
> > lab, I can't enter the ls1010, how can i know the lecs nsap address?
> >
> > TIA
> > JASON CHEN
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:58 GMT-3