From: Martin Bander (cisco103@xxxxxxxxxxx)
Date: Sat Dec 04 1999 - 19:46:48 GMT-3
Don't forget the ebgp-multihop comand, since r1's loopback interface is not
'directly connected' to r2.
----Original Message Follows----
From: "hon-siong chan" <honsiong@hotmail.com>
Reply-To: "hon-siong chan" <honsiong@hotmail.com>
To: ccielab@groupstudy.com
Subject: BGP Update-source
Date: Thu, 02 Dec 1999 20:28:02 PST
I followed Sam Halabi book on configuring a simple BGP peering by pointing
to a loopback interface. Scenario is as simple as follows:
-----R1 --------R2
Where R1 has a loopback interface and both are in same AS. In R1, command
as:
neighbor <R2> remote-as 100
neighbor <R2> update-source loopback 0
The peering can never be established since then. A "Sh ip bgp neigh" showed
"Active" status only?!
What's wrong?
Thanks in advance....
HonSiong
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:58 GMT-3