From: Martin Bander (cisco103@xxxxxxxxxxx)
Date: Thu Dec 02 1999 - 15:50:21 GMT-3
I tried both and every combination of the two. It still performs inverse
arp. It even removes the 'no frame-relay invers-arp' command from my
running config. I perform a 'show run' and I see the 'no frame-relay
invers-arp' under the interface. I then perform a 'clear
fram-relay-inversearp' then again I show the running config and boom!
Command is gone.
There has to be a trick to this!
Try It.
R5
/ \
R4 R3
R5 has 2 sub-interfaces
R4/R3 both use physical interfaces.
Frame switch is full mesh
I only want to use the PVC's as shown above. I use map statements for R3 to
R5 and R4 to R5. I do not want to use the PVC between R4 and R3. no
fram-relay inver-arp should resolve this problem. It does not.
----Original Message Follows----
From: "Stephens, Paul [Prof.Serv]" <Paul.Andrew.Stephens@compaq.com>
To: 'Martin Bander' <cisco103@hotmail.com>, ccielab@groupstudy.com
Subject: RE: Frame Relay
Date: Thu, 2 Dec 1999 18:06:07 -0000
You'll have to either reload the router after setting the command or issue
the clear frame-relay-inarp command. It seems to do an inverse-arp all the
time until you have cleared it either by reloading or by the command above
Paul Stephens
UK INI Network Consultant
Networks and Systems Integration Services
Compaq Computer Ltd
*mailto:paul.andrew.stephens@compaq.com
<mailto:paul.andrew.stephens@compaq.com>
* Mobile +44 7818 457948
-----Original Message-----
From: Martin Bander [mailto:cisco103@hotmail.com]
Sent: Thursday, December 02, 1999 17:32
To: ccielab@groupstudy.com
Subject: Frame Relay
All,
I'm trying to disable inverse-arp for a particular delci. I
already tried
the interface command 'No frame-relay inverse arp'. Didn't
work. Has
anybody worked through this?
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:58 GMT-3