From: Brett Summerville (phreeze@xxxxxxxxx)
Date: Thu Dec 02 1999 - 17:18:52 GMT-3
Make sure you have frame relay map statements in and not "frame relay
interface-dlci 100"... Keep the no frame inverse-arp command applied.
-----Original Message-----
From: Martin Bander <cisco103@hotmail.com>
To: Paul.Andrew.Stephens@compaq.com <Paul.Andrew.Stephens@compaq.com>;
ccielab@groupstudy.com <ccielab@groupstudy.com>
Date: Thursday, December 02, 1999 2:28 PM
Subject: RE: Frame Relay
>I tried both and every combination of the two. It still performs inverse
>arp. It even removes the 'no frame-relay invers-arp' command from my
>running config. I perform a 'show run' and I see the 'no frame-relay
>invers-arp' under the interface. I then perform a 'clear
>fram-relay-inversearp' then again I show the running config and boom!
>Command is gone.
>
>There has to be a trick to this!
>
>Try It.
>
> R5
> / \
> R4 R3
>
>R5 has 2 sub-interfaces
>R4/R3 both use physical interfaces.
>
>Frame switch is full mesh
>
>I only want to use the PVC's as shown above. I use map statements for R3
to
>R5 and R4 to R5. I do not want to use the PVC between R4 and R3. no
>fram-relay inver-arp should resolve this problem. It does not.
>
>
>
>----Original Message Follows----
>From: "Stephens, Paul [Prof.Serv]" <Paul.Andrew.Stephens@compaq.com>
>To: 'Martin Bander' <cisco103@hotmail.com>, ccielab@groupstudy.com
>Subject: RE: Frame Relay
>Date: Thu, 2 Dec 1999 18:06:07 -0000
>
>You'll have to either reload the router after setting the command or issue
>the clear frame-relay-inarp command. It seems to do an inverse-arp all the
>time until you have cleared it either by reloading or by the command above
>
>Paul Stephens
>
>UK INI Network Consultant
>Networks and Systems Integration Services
>Compaq Computer Ltd
>
>*mailto:paul.andrew.stephens@compaq.com
><mailto:paul.andrew.stephens@compaq.com>
>* Mobile +44 7818 457948
>
>
>
> -----Original Message-----
> From: Martin Bander [mailto:cisco103@hotmail.com]
> Sent: Thursday, December 02, 1999 17:32
> To: ccielab@groupstudy.com
> Subject: Frame Relay
>
> All,
>
> I'm trying to disable inverse-arp for a particular delci. I
>already tried
> the interface command 'No frame-relay inverse arp'. Didn't
>work. Has
> anybody worked through this?
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:58 GMT-3