From: Mike Wang (mike_wang51@xxxxxxxxxxx)
Date: Wed Oct 20 1999 - 03:53:37 GMT-3
I thought pvc 0 16 ilmi has already communicate with switch to get the
network prefix. usually you have 4 lines under physical int atm 0
pvc 1 0 5 ..
pvc 2 0 16 ..
lane config data ....
lane config auto...
What do you mean hard code one? I do not need to hard code esi add. or arp
server here as it is not a SVC config.
Thanks,
Mike
>From: "Peter Van Oene" <vantech@sympatico.ca>
>To: "Mike Wang" <mike_wang51@hotmail.com>, <ccielab@groupstudy.com>
>CC: <mike_wang51@hotmail.com>
>Subject: Re: atm question
>Date: Tue, 19 Oct 1999 19:52:32 -0700
>
>Comments inserted..
>
>Peter Van Oene
>Senior Systems Engineer
>UNIS LUMIN Inc.
>www.unislumin.com
>
>----- Original Message -----
>From: Mike Wang <mike_wang51@hotmail.com>
>To: <ccielab@groupstudy.com>
>Cc: <mike_wang51@hotmail.com>
>Sent: Monday, October 18, 1999 10:20 AM
>Subject: atm question
>
>
> > Hi,
> >
> > I run into two ATM commands do not know when to use them.
> >
> > 1. Caslow's book put "lane auto-config-atm-address" under int atm 0,
> > I also found this from some other resources, but some did not. Based
>on
> > my lab experience, you DO NOT need this command to make lane working. So
> > could anyone point out to me WHEN it is a MUST to use this command? or
>you
> > don't need this command at all?
>
>This is used when you want to learn your ATM network prefix from the ATM
>switch via ILMI. You can certainly hard code to avoid this.
>
> >
> > 2. When to use "ATM Preferred Phy A" command?
> >
>
>This is used on a Cat5k LANE module which has two ATM physical ports. You
>need to select one for the module to know which to use. This is very much
>like the media-type 10BaseT command on the 4000 series router.
>
>
> > Thanks a lot,
> > Mike
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:53 GMT-3