From: Pamela Forsyth (pforsyth@xxxxxxxxx)
Date: Wed Sep 29 1999 - 23:40:12 GMT-3
Mark,
I didn't notice a reply to your question. You can't filter on an
interface in NLSP, but at area boundaries. You can filter both routing
information and services. The multiple areas are a bit tricky to set up,
though, and the Cisco documentation is quite opaque on the subject. I can
post some additional info on this to the group this weekend when I get
back to home base, if anyone is interested.
Pamela
On Tue, 28 Sep 1999, Mark Detrick wrote:
> Is there any way to filter NLSP routes or saps, either in or out from an inte
rface? It is a LS protocol, therfore, I'm
> inclined to think not.
>
> Thanks,
> --
> Mark S. Detrick
> Cisco Systems
> QA Engineer
> Irvine, CA 92612
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:51 GMT-3