Re: Trouble with apple DDR

From: Brian Van Benschoten (vader@xxxxxxxxxxxx)
Date: Tue Sep 14 1999 - 23:39:07 GMT-3


   
I seem to remember a problem like this happening to me. I think i had to
use tunnels to solve the problem. However, I dont remember why
----- Original Message -----
From: Edward Taggart <etaggart@pivot.net>
To: <ccielab@groupstudy.com>
Sent: Sunday, September 12, 1999 10:46 PM
Subject: Trouble with apple DDR

I'm trying to configure apple DDR over to async modems. I've had no
problems with IP and IPX, but i'm getting encapsulation failed messages when
trying to send appletalk over my ddr link. I'm stumped... R3 is setup to
call R5. Here are some snippets from the configs...

R3
====
interface Async1
 ip address 132.4.9.3 255.255.255.0
 encapsulation ppp
 bandwidth 19200
 dialer in-band
 dialer map ipx 35.0005.0005.0005 name R5 modem-script dial broadcast
6427891
 dialer map ip 132.4.9.5 name R5 modem-script dial broadcast 6427891
 dialer map appletalk 35.5 name R5 modem-script dial broadcast 6427891
 dialer-group 1
 async dynamic routing
 async mode dedicated
 appletalk cable-range 35-35 35.3
 appletalk zone 35
 ipx network 35
 no ipx route-cache
 ipx watchdog-spoof
 ppp chap hostname R3
!
dialer-list 1 protocol ip permit
dialer-list 1 protocol ipx list 901
dialer-list 1 protocol appletalk permit

R5
===
interface Async1
 ip address 132.4.9.5 255.255.255.0
 encapsulation ppp
 dialer in-band
 dialer map ip 132.4.9.3 name R3 broadcast
 dialer map appletalk 35.3 name R3 broadcast
 dialer map ipx 35.0003.0003.0003 name R3 broadcast
 dialer-group 1
 async dynamic routing
 async mode dedicated
 appletalk cable-range 35-35 35.5
 appletalk zone 35
 ipx network 35
 ppp authentication chap
 ppp chap hostname R5
!
dialer-list 1 protocol ip permit
dialer-list 1 protocol ipx list 901
dialer-list 1 protocol appletalk permit

Here's some debug info:
R3#sho dialer

Async1 - dialer type = IN-BAND ASYNC NO-PARITY
Idle timer (120 secs), Fast idle timer (20 secs)
Wait for carrier (30 secs), Re-enable (15 secs)
Dialer state is data link layer up
Dial reason: appletalk (s=35.3, d=0.255)
Time until disconnect 118 secs
Connected to 6427891

Dial String Successes Failures Last called Last status
6427891 1 0 never

R3#sho apple nei
AppleTalk neighbors:
  431.4 Serial0.1, uptime 00:57:22, 2 secs
        Neighbor is reachable as a RTMP peer

R3#sho apple route
Codes: R - RTMP derived, E - EIGRP derived, C - connected, A - AURP
       S - static P - proxy
2 routes in internet

The first zone listed for each entry is its default (primary) zone.

C Net 35-35 directly connected, Async1, zone 35
C Net 431-432 directly connected, Serial0.1, zone frame

R3#debug apple packet int as 1
AppleTalk packets debugging is on for interface Async1
R3#ping apple 35.5

Type escape sequence to abort.
Sending 5, 100-byte AppleTalk Echos to 35.5, timeout is 2 seconds:

00:59:51: Async1: encapsulation failed AT packet: enctype PPP, size 29
00:59:51:
2052544D5020706B742073656E740A301841812B|001DA6E100000023FF03010101002
30803
00:59:51:
00238000238201AF8001B082530002000000010002002B000000040002002500000431
0001
00:59:51: Async1: input AT packet: enctype PPP, size 29
00:59:51:
2052544D5020706B742073656E740A301841812B|001DA6E100000023FF03010101002
30803
00:59:51:
00238000238201AF8001B082530002000000010002002B000000040002002500000431
0001
00:59:53: Async1: encapsulation failed AT packet: enctype PPP, size 100
00:59:53:
00000000000000000000000000000000FCF10309|0064EE4500230023050304FD04010
00011
00:59:53:
D1000000000036D3340000000000000000000000000000000000000000000000000000
0000
00:59:53: Async1: input AT packet: enctype PPP, size 100
00:59:53:
00000000000000000000000000000000FCF10309|0064EE4500230023050304FD04010
00011
00:59:53:
D1000000000036D3340000000000000000000000000000000000000000000000000000
0000E
00:59:55: Async1: encapsulation failed AT packet: enctype PPP, size 100
00:59:55:
0000000000000000000000000000000018418137|0064EE4C00230023050304FD04010
00011
00:59:55:
D2000000000036DB040000000000000000000000000000000000000000000000000000
0000
00:59:55: Async1: input AT packet: enctype PPP, size 100
00:59:55:
0000000000000000000000000000000018418137|0064EE4C00230023050304FD04010
00011
00:59:55:
D2000000000036DB040000000000000000000000000000000000000000000000000000
0000E
00:59:57: Async1: encapsulation failed AT packet: enctype PPP, size 100
00:59:57:
0000000000000000000000000000000018418137|0064DE5B00230023050304FD04010
00011
00:59:57:
D3000000000036E2D40000000000000000000000000000000000000000000000000000
0000
00:59:57: Async1: input AT packet: enctype PPP, size 100
00:59:57:
0000000000000000000000000000000018418137|0064DE5B00230023050304FD04010
00011
00:59:57:
D3000000000036E2D40000000000000000000000000000000000000000000000000000
0000E
00:59:59: Async1: encapsulation failed AT packet: enctype PPP, size 100
00:59:59:
0000000000000000000000000000000018418137|0064DE6200230023050304FD04010
00011
00:59:59:
D4000000000036EAA40000000000000000000000000000000000000000000000000000
0000
00:59:59: Async1: input AT packet: enctype PPP, size 100
00:59:59:
0000000000000000000000000000000018418137|0064DE6200230023050304FD04010
00011
00:59:59:
D4000000000036EAA40000000000000000000000000000000000000000000000000000
0000E
01:00:01: Async1: encapsulation failed AT packet: enctype PPP, size 100
01:00:01:
0000000000000000000000000000000018410800|00641E6A00230023050304FD04010
00011
01:00:01:
D5000000000036F27C0000000000000000000000000000000000000000000000000000
0000

This seems pretty straight forward and I've done this on ISDN before without
a problem. Any help would be appreciated.

Thanks! - Ed

Edward C. Taggart
etaggart@pivot.net
http://wwp.icq.com/2034197
ICQ#:2034197
AIM:etaggart2



This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:50 GMT-3