RE: CPU time

From: Jinho Hong (sthong@xxxxxxxxxxxx)
Date: Sun Aug 15 1999 - 22:35:09 GMT-3

• Next message: Bill Carter: "EIGRP Default Route"
• Previous message: Chad Marsh: "Re: Appletalk Ping"
• Maybe in reply to: George Harizanov: "CPU time"
• Next in thread: Jim Ayers: "Re: CPU time"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
   Hi,
   
   I think you can do it.
   
   Most of protocol uses timer, if you use timer, you can control cpu
   loads.
   
   For example,
   
   Ospf cpu load control, you can use timer....
   
   
   
   Regards,
   Jinho Hong
   
   -----Original Message-----
   ·ol : George Harizanov <georgehar@prodigy.net>
   ^¶æ : ccielab@groupstudy.com <ccielab@groupstudy.com>
   "ú : 1999"N8OE14"ú 10:37
   OE-¼ : CPU time
   
   Hi guys...
   
   
   
   I've being trying to figure this one out for some time..
   
   Is there a way a routing protocol (ospf, bgp, and so on ) can be
   limited to certain CPU time usage on the router?
   
   Any hints or directions to the cisco site where this might be
   discussed .. would be appreciated..
   
   
   
   Thanks
   
   George

• Next message: Bill Carter: "EIGRP Default Route"
• Previous message: Chad Marsh: "Re: Appletalk Ping"
• Maybe in reply to: George Harizanov: "CPU time"
• Next in thread: Jim Ayers: "Re: CPU time"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:46 GMT-3