From: Derek Fage (DerekF@xxxxxxxxxxx)
Date: Mon Aug 09 1999 - 12:15:51 GMT-3
It's difficult to tell what the problem is when we can only see config of
the spoke router.
Work at it from a layer 2 level first
- Can both spoke routers ping the hub router ?
- Can the hub router ping both spoke router ?
- Do show frame map on hub and spoke routers - are these correct ?
If you get encaps failed on debug apple, try debug frame packet on the spoke
router. Does the packet get sent over the frame ? If it goes out but does
not come back, debug apple and frame packets on the hub router.
Once you have that working, move to layer 3.
- Do you have split horizon disabled (apple eigrp-split disa) ?
I do not think that the 'apple local-routing' command is required unless you
have another interface for routing appletalk on the same router, but would
need to test it to confirm it.
Let us know how it goes.
Derek...
> -----Original Message-----
> From: Chuah Eng Wee [SMTP:chuahew@cyberway.com.sg]
> Sent: 09 August 1999 06:46
> To: ccielab@groupstudy.com
> Subject: appletalk frame relay ping own interface
>
> Hi..
>
> Have some problems with this appletalk in frame relay environment :
>
> basically 3 router is hub and spoke topology. Hub router use
> multipoint subinterface, spoke router use physical interface.
>
> The spoke router cannot ping the other spoke router and its own interface
> despite having the config below
>
>
> interface Serial0
> ip address 137.20.1.3 255.255.255.0
> encapsulation frame-relay
> ip ospf network broadcast
> ip ospf priority 0
> appletalk cable-range 1002-1002 1002.221
> appletalk zone r1r3r5serial
> appletalk protocol eigrp
> no appletalk protocol rtmp
> frame-relay map appletalk 1002.221 301 broadcast (map to itself)
> frame-relay map appletalk 1002.103 301 broadcast (map to another
> spoke)
> frame-relay map appletalk 1002.243 301 broadcast (map to hub)
> frame-relay map ip 137.20.1.3 301 broadcast
> frame-relay map ip 137.20.1.5 301 broadcast
> frame-relay map ip 137.20.1.1 301 broadcast
>
> Debug apple packet doesn't shows any encap failure.
>
> Did i miss out anything ??
>
>
> Thanks
> ENg Wee
>
>
>
>
>
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:46 GMT-3