From: hon-siong chan (honsiong@xxxxxxxxxxx)
Date: Fri Aug 06 1999 - 00:13:52 GMT-3
EIGRP will take in the classful network in "network x.x.x.x" command only.
If you can't see eigrp being redistributed into ospf, it could be subnet
left out with "redistribute eigrp <AS#> subnets" command.
It may be some addressing assignment error on your interface. In normal
case, when you have 2 peering routers running eigrp, say on S0 & S0
interfaces, a "sh ip eigrp neigh" or "sh ip eigrp int" will show the
appropriate peerings.
Hope this help.....
HonSiong
>From: "Rahmlow, Howard F." <howard.rahmlow@unisys.com>
>Reply-To: "Rahmlow, Howard F." <howard.rahmlow@unisys.com>
>To: ccielab@groupstudy.com
>Subject: OSPF and EIGRP
>Date: Thu, 5 Aug 1999 19:46:02 -0400
>
>In a lab setup, I have both EIGRP and OSPF running. Here is the basic setup
>
>Int S0
>ip add 192.63.65.6 255.255.255.252
>
>Int S1
>ip add 192.63.65.9 255.255.255.252
>
>Router EIGRP 100
>network 192.63.65.0
> (every time I enter 192.63.65.4, it changes in the show run)
>
>Router OSPF 100
>network 192.63.65.8 0.0.0.3 area 0
>
>When I try and redistribute the routes, the OSPF routes make it to the
>EIGRP
>side no problem, but the EIGRP routes are not seen on the OSPF side. If I
>look at the eigrp interfaces, or neighbors, they both show S1.
>
>Any clue?
>Thanks in advance, Howard
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:46 GMT-3