From: Nentarz, Dave (Dave.Nentarz@xxxxxxxxxx)
Date: Thu Aug 05 1999 - 22:30:35 GMT-3
The eigrp flash back from subnet to network is normal - IGRP will do that
too. You only need to configure the NETwork - if you put in a subnet - it
will convert it _for_ you.
Make sure you remember the subnets keyword when distributing anything into
OSPF.
Dave
-----Original Message-----
From: Rahmlow, Howard F. [mailto:howard.rahmlow@unisys.com]
Sent: Thursday, August 05, 1999 7:46 PM
To: ccielab@groupstudy.com
Subject: OSPF and EIGRP
In a lab setup, I have both EIGRP and OSPF running. Here is the basic setup
Int S0
ip add 192.63.65.6 255.255.255.252
Int S1
ip add 192.63.65.9 255.255.255.252
Router EIGRP 100
network 192.63.65.0
(every time I enter 192.63.65.4, it changes in the show run)
Router OSPF 100
network 192.63.65.8 0.0.0.3 area 0
When I try and redistribute the routes, the OSPF routes make it to the EIGRP
side no problem, but the EIGRP routes are not seen on the OSPF side. If I
look at the eigrp interfaces, or neighbors, they both show S1.
Any clue?
Thanks in advance, Howard
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:46 GMT-3