From: Derek Fage (DerekF@xxxxxxxxxxx)
Date: Tue Jul 20 1999 - 12:59:20 GMT-3
I'm running through some final configuration scenarios, and need a bit of
advice about this.
I'm trying to setup a DLSW+ configuration using border peers.
In group 1 I have 3 peers and a border peer, and in group 2 I have 3 peers
and a border peer.
Border peers are configured as follows:
dlsw local-peer peer-id nnn.nnn.nnn.nnn group 1 border promiscous
dlsw remote-peer 0 tcp nnn.nnn.nnn.nnn (address of group 2 border peer)
Group peers are configured as follows:
dlsw local-peer peer-id nnn.nnn.nnn.nnn group 1 (or 2)
dlsw remote-peer 0 tcp nnn.nnn.nnn.nnn (address of border peer for this
group).
All appears fine, and the capabilities for the peers look correct - I just
want to understand a bit more how this works.
Let's look at the situation where a SRB client attached to the ring of a
peer client in group 1 wants to connect to an SRB server attached to the
ring of a peer client in group 2.
Am I correct in assuming that the individual peers will send all of the
traffic via the border peer router to the remote site (once the ARE has
established the route) ? Is this also the case between peers in the same
group ?
Derek...
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:42 GMT-3