Re: OSPF / IGRP

From: Chuah Eng Wee (chuahew@xxxxxxxxxxxxxxx)
Date: Wed Jul 14 1999 - 07:19:52 GMT-3

• Next message: Stanley Seow: "OSPF Loopback Interface"
• Previous message: Stanley Seow: "OSPF / IGRP"
• Maybe in reply to: Stanley Seow: "OSPF / IGRP"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Hi Stanley,

Yes, u need to put metric whenever u redistribute OSPF (in fact any routing
protocol) into IGRP or EIGRP
becos IGRP and EIGRP don't understand OSPF's metric. The very big -ve
number indicates unreachable.

For redistribution from IGRP/EIGRP into OSPF, id metric not specified,
it'll be 20 (assuming E2)

U need to specify metric as well when u redistribute other protocols to RIP.

HTH
ENg Wee

At 14:32 14/07/99 +0800, Stanley Seow wrote:
>I'm doing a OSPF / IGRP redistribution lab, when I redistribute a OSPF IA
>route into IGRP, the metric sent is a very high figure ( or -ve numbers )
>and the route does not appear on IGRP router.
>
>But when I put in the metrics ( BW, Delay, Load, Re, MTU ) during the OSPF
>to IGRP redistribution, the route appear on the IGRP routers.
>
>Any idea why this happens ?
>
>Must I put the metric everytime I redistribute OSPF into IGRP ?
>
>Stanley
>
>
>
>

• Next message: Stanley Seow: "OSPF Loopback Interface"
• Previous message: Stanley Seow: "OSPF / IGRP"
• Maybe in reply to: Stanley Seow: "OSPF / IGRP"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:42 GMT-3