From: Ben Rife (brife@xxxxxxxxxx)
Date: Sat Jul 03 1999 - 14:30:00 GMT-3
Hi guys,
I have a partial mesh frame relay setup. My hub is using a multipoint
interface to connect to two spokes. The spokes are physical
interfaces. IP is working perfectly. All interfaces are on the same
subnet.
What I want to do is configure an AT tunnel from each spoke to the
hub. Is this possible with a multipoint interface at the hub? I can
get one spoke up but when I try the other, I get an error message (at
the hub)stating that there was a conflict.
Any ideas?
Benjy Rife
MCSE, CNE, CCIE Candidate
brife@bignet.net
www.bignet.net/~brife
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:41 GMT-3