From: Rick Burts (burts@xxxxxxxx)
Date: Sat Jun 05 1999 - 15:12:08 GMT-3
Inverse ARP is enabled by default on Frame Relay interfaces where
the PVCs are mapped to the main (physical) interface. And the
original post did specifically state that he did not use
subinterfaces. So the frame-relay inverse-arp command is redundant.
The problem is almost certainly problems in associating layer 3
addresses to layer 2 addresses and the solution is, as Joel has
suggested, the frame-relay map ipx ... commands.
Rick
On Thu, 3 Jun 1999, Srikanth Nagarajan wrote:
> Another alternative is to enable inverse arp on the frame relay interface by
> which both ends could determine their protocol addresses
>
> Command is
>
> (config-if)#frame-relay inverse-arp
>
> Thanks
> Srikanth N
>
> >From: "Ekis, Joel" <Joel.Ekis@Connect.Xerox.com>
> >Reply-To: "Ekis, Joel" <Joel.Ekis@Connect.Xerox.com>
> >To: rudy.phen@datacraft-asia.com, ccielab@groupstudy.com
> >Subject: RE: IPX over frame relay
> >Date: Thu, 3 Jun 1999 07:59:38 -0400
> >
> >You will need 'frame-relay map ipx ... broadcast' statements on every
> >spoke.
> >Otherwise you will not have IPX connectivity between the spokes. Also,
> >make
> >sure you turn off the IPX RIP or you will be dumping extra broadcast
> >traffic
> >on the F/R circuits needlessly.
> >
> >Joel Ekis, CCNA, CCDA
> >Xerox Connect
> >Sr. Enterprise Consultant/Enterprise Network Services
> >Phone: 913-696-0888, x234
> >Pager: 800-697-0359
> >joel.ekis@connect.xerox.com <mailto:joel.ekis@connect.xerox.com>
> >
> >
> > -----Original Message-----
> > From: rudy.phen@datacraft-asia.com
> >[SMTP:rudy.phen@datacraft-asia.com]
> > Sent: Thursday, June 03, 1999 6:28 AM
> > To: ccielab@groupstudy.com
> > Subject: IPX over frame relay
> >
> > Next month is a big day... hopefully new CCIE coming...
> > I am currently testing on my lab for ipx over frame relay
> >configuration.
> > I did not using subinterfaces.. but i using IPX Eigrp on the hub dan
> >spoke router and I turn off the split horizon.
> > the result is I got all the ipx route.. (perfect..)
> > but the problem is I can not ping from one spoke router to another
> >spoke router.. even ping to the frame relay interface on that spoke router
> >(that connected to hub router)..
> > I have check all the config.. it's look correctly configure..
> > Pls consult..... thanks in adv..
> >
> > Cheers
> > Rudy Phen
> > Startrac - Datacraft Asia Ltd.
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:38 GMT-3