neighbor command

From: Chuah Eng Wee (chuahew@xxxxxxxxxxxxxxx)
Date: Tue Apr 06 1999 - 12:18:36 GMT-3

• Next message: Cavanaugh, Mike J (CAP, ITS, US): "RE: neighbor command"
• Previous message: Scott Morris: "Backup and Dialers"
• Next in thread: Cavanaugh, Mike J (CAP, ITS, US): "RE: neighbor command"
• Maybe reply: Cavanaugh, Mike J (CAP, ITS, US): "RE: neighbor command"
• Maybe reply: "Rudy Phen": "re: neighbor command"
• Maybe reply: Joe Soricelli: "Re: neighbor command"
• Maybe reply: Chuah Eng Wee: "Re: neighbor command"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
Hi all,

I have 3 routers in an NBMA network.

The hub router uses point-to-point subinterface
Two spoke router use physical interface

I want to make the hub router a DR, therefore, at the hub router, i use

router ospf 10
  network ......
  neighbor spokeA-ip
  neighbor spkeB-ip

At spokeA,
router ospf 10
   neigh Hub-ip priority 10

At spokeB,
   neigh Hub-ip priority 10

I read from the documentation that if no priority is not specified, it'll
be priority 0,
which implies it will not participate in DB/BRD election. However, I get a
priority of 1
when I did not specify it. At the spoke, the configuration will change the
priority to 1
after a while even when I keyed in the priority to be 10.

Any idea what did I miss out or there's bug in the IOS ??

Thanks
Eng Wee

• Next message: Cavanaugh, Mike J (CAP, ITS, US): "RE: neighbor command"
• Previous message: Scott Morris: "Backup and Dialers"
• Next in thread: Cavanaugh, Mike J (CAP, ITS, US): "RE: neighbor command"
• Maybe reply: Cavanaugh, Mike J (CAP, ITS, US): "RE: neighbor command"
• Maybe reply: "Rudy Phen": "re: neighbor command"
• Maybe reply: Joe Soricelli: "Re: neighbor command"
• Maybe reply: Chuah Eng Wee: "Re: neighbor command"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:36 GMT-3