MDS Zoneset Configuration Question

Hello All,

   I was wondering something in regards to configuring zones and
initiators on an MDS. Under the Zoneset name "Name" is there a different
between using member (Zone name) verses just using zone name (zone name)? In
the guide looks pretty much the same

Command

Purpose

Step 1
switch# config t

Enters configuration mode.

Step 2

switch(config)#
zoneset name Zoneset1 vsan 3
switch(config-zoneset)#

Configures a zone set
called Zoneset1.
Tip To activate a zone set, you must first create the zone
and a zone set.

Step 3

switch(config-zoneset)# member Zone1

Adds Zone1
as a member of the specified zone set (Zoneset1).
Tip If the specified zone
name was not previously configured, this command will return the Zone not
present error message.

Step 4

switch(config-zoneset)# zone name
InlineZone1

switch(config-zoneset-zone)#

Adds a zone (InlineZone1) to
the specified zone set (Zoneset1).
Tip Execute this step only if you need to
create a zone from a zone set prompt.

Thanks,

James

Blogs and organic groups at http://www.ccie.net
Received on Mon Dec 08 2014 - 18:26:57 ART