Re: Need help with LACP Trunking on 4948 switch

Kaivalya- that's great teamwork, thanks for the response.

Regards,
Jay McMickle- 2x CCIE #35355 (R/S,Sec)
Sent from my iPhone 5

> On May 28, 2014, at 5:37 PM, Kaivalya Patel <Kaivalya_at_hotmail.com> wrote:
>
> http://support.f5.com/kb/en-us/products/big-ip_ltm/manuals/product/tmos_mana
> gement_guide_10_1/tmos_trunks.html
>
> LACP need to be negotiated as you may know... make sure LACP is checked and
> service is running on F5...
>
> Hope this helps...
> Thanks
> Kal
>
> -----Original Message-----
> From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
> Jersey Guy
> Sent: Wednesday, May 28, 2014 5:13 PM
> To: Cisco certification
> Subject: Need help with LACP Trunking on 4948 switch
>
> Hello Experts,
> I am trying to run an LACP trunk between an old 4948 switch running 12.2
> IOS, and a new 8900 F5 LTM. The trunk comes up, all the interfaces come up,
> no errors etc....but there is zero input traffic:
>
> 5 minute input rate 0 bits/sec, 0 packets/sec
> 5 minute output rate 6000 bits/sec, 10 packets/sec.
>
> The F5 LTM is set to flow control off. Even if I try changing the flow
> control settings, it doesn't do anything. On the switch side I see:
> input flow-control is off, output flow-control is unsupported
>
> I tried forcing the output flowcontrol to off but on this 4948, there is
> only receive/input option, nothing for transmit/send/output flowcontrol.
>
> Here is the switch config (port channel and one of the interfaces in this
> port channel):
>
> interface Port-channel5
> switchport
> switchport trunk encapsulation dot1q
> switchport trunk allowed vlan 322
> switchport mode trunk
> logging event link-status
> logging event trunk-status
>
> interface GigabitEthernet1/6
> switchport trunk encapsulation dot1q
> switchport trunk allowed vlan 322
> switchport mode trunk
> service-policy input DH-ING
> logging event link-status
> speed 1000
> duplex full
> tx-queue 1
> bandwidth percent 5
> tx-queue 2
> bandwidth percent 25
> tx-queue 3
> priority high
> shape percent 30
> tx-queue 4
> bandwidth percent 40
> spanning-tree portfast
> spanning-tree bpduguard enable
> channel-group 5 mode active
>
> Any help/insight will be most appreciated!
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Wed May 28 2014 - 18:52:51 ART