Re: Apply ACL on SVI

Hi Vishal,

This is not possible on some Cisco switches. It will be useful if you can
specify the switch hardware and software version.

Sadiq

On Mon, Nov 11, 2013 at 2:19 PM, Vishal Rane <vishal.rane_at_hotmail.co.in>wrote:

> Hello
> Here is scenario for ACL on SVI
> plz guide with right inbond / outbond acl to apply on SVI
>
>
> office_A connect to Office_B on different floors on vlan 10
> need to allow inbond and outbond traffic
> Config of Office_A and host
> VLAN
> int vlan 10
> ip address 192.168.177.254 255.255.255.252
> Allow the following host to communicate with host of Office_B
> host 192.168.110 port 443
> host 192.168.1.16
> network 192.168.25.0/24
> Network of Office_B
> allow following host to communicate with hos of Office_A
> 192.168.100.10 port 443
> 1192.168.100.17
> 192.168.27.0/24
>
>
> thanks
> Vishal
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>

-- 
CCIEx2 (R&S|Sec) #19963
Blogs and organic groups at http://www.ccie.net