Re: poe issue

is it any thing that low end models work with cat5 and high end with cat
6?

On Wed, Aug 14, 2013 at 8:57 PM, Karl Young <kaelwyoung_at_netscape.net> wrote:

> Imran,
> Check the Cat 5 cable ! you might have a bad drop.
> Karl.
>
>
> ----Original Message-----
> From: Imran Ali <immrccie_at_gmail.com>
> To: Cisco certification <ccielab_at_groupstudy.com>
> Sent: Wed, Aug 14, 2013 1:31 pm
> Subject: poe issue
>
> Guys
>
> if i take my 7945 ip phone to switch room and connect it . its
> getting poe and registering fine .
>
> but when i go out to cubicle where user is sitting and connect it over
> to same port . (cable patched by patch pannel ) .. their is no poe.
>
> when i connect 7912 .. smaller ip phone ..it get poe from the cubicle
> . This is strange .
>
> both phones has different poe needs ? it is depondent on cable cat 5, 6
> etc ?
>
> is their any way to boost up poe from the switchport ?
>
>
> i tried some options
>
> power inline auto ....
> shut no shut
> reload switch ...
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at: http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Wed Aug 14 2013 - 22:55:26 ART