Re: Destination policy NAT on ASA 8.2 to Symantec proxy on

So you need the pre nat source to go to Symantec?

Sent from handheld.

On Apr 17, 2013, at 9:40 AM, "Tauseef Khan"
<tasneemjan_at_googlemail.com<mailto:tasneemjan_at_googlemail.com>> wrote:

Hi Rayn,

inside network 10.50.0.0/16<http://10.50.0.0/16>
outside interface ip 207.195.111.1/24<http://207.195.111.1/24>
syamnatec proxy server 2.27.27.27/32<http://2.27.27.27/32>
All the traffic from inside to go outside is already natted on OUTSIDE
interface with nat 1 and global 1
Regards

Kind regards

Tauseef
mobile: +44 7837209187

On 17 April 2013 14:18, Ryan West <rwest_at_zyedge.com<mailto:rwest_at_zyedge.com>>
wrote:
Tauseef,

It's pretty much the same as a NAT 0. I think it's easier in 8.2, if you give
me some IPs to work with, I can provide it.

-----Original Message-----
From: nobody_at_groupstudy.com<mailto:nobody_at_groupstudy.com>
[mailto:nobody_at_groupstudy.com<mailto:nobody_at_groupstudy.com>] On Behalf Of Jay
McMickle
Sent: Wednesday, April 17, 2013 9:15 AM
To: Tauseef Khan
Cc: Cisco certification
Subject: Re: Destination policy NAT on ASA 8.2 to Symantec proxy on internet

What transparent forwarding protocol is supported by Symantec? Cisco ASA
supports WCCP redirect for the respective protocol (http, https, ftp, etc.),
but I don't know that I would send that over the Internet. What about a VPN
tunnel to them and send WCCP to them?

Regards,
Jay McMickle CCIE #35355
Sent from my iPhone

On Apr 17, 2013, at 8:10 AM, Tauseef Khan
<tasneemjan_at_googlemail.com<mailto:tasneemjan_at_googlemail.com>> wrote:

> Hi all, Appreciate if some one could take a look. I have ASA 8.2 with
> nating as below nat (inside) 1 access-list NAT_ALL global (outside) 1
> interface OUTSIDE accees-list NAT_ALL permit any any
>
> So all traffic going to outside is natted behind the OUTSIDE
> interface. I have a requirement that all traffic going to internet
> (OUTSIDE interface) should be forwarded to a transparent proxy (symantec
managed service).
> I know this is achievable on 8.4 and 9.0 but is there anyway I can do
> this on ASA8.2 Thanks in advance
>
> Kind regards
>
> Tauseef
> mobile: +44 7837209187<tel:%2B44%207837209187>
>
>
> Blogs and organic groups at http://www.ccie.net
>
> ______________________________________________________________________
> _ Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Wed Apr 17 2013 - 13:43:24 ART