Tauseef,
It's pretty much the same as a NAT 0. I think it's easier in 8.2, if you give me some IPs to work with, I can provide it.
-----Original Message-----
From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of Jay McMickle
Sent: Wednesday, April 17, 2013 9:15 AM
To: Tauseef Khan
Cc: Cisco certification
Subject: Re: Destination policy NAT on ASA 8.2 to Symantec proxy on internet
What transparent forwarding protocol is supported by Symantec? Cisco ASA supports WCCP redirect for the respective protocol (http, https, ftp, etc.), but I don't know that I would send that over the Internet. What about a VPN tunnel to them and send WCCP to them?
Regards,
Jay McMickle CCIE #35355
Sent from my iPhone
On Apr 17, 2013, at 8:10 AM, Tauseef Khan <tasneemjan_at_googlemail.com> wrote:
> Hi all, Appreciate if some one could take a look. I have ASA 8.2 with
> nating as below nat (inside) 1 access-list NAT_ALL global (outside) 1
> interface OUTSIDE accees-list NAT_ALL permit any any
>
> So all traffic going to outside is natted behind the OUTSIDE
> interface. I have a requirement that all traffic going to internet
> (OUTSIDE interface) should be forwarded to a transparent proxy (symantec managed service).
> I know this is achievable on 8.4 and 9.0 but is there anyway I can do
> this on ASA8.2 Thanks in advance
>
> Kind regards
>
> Tauseef
> mobile: +44 7837209187
>
>
> Blogs and organic groups at http://www.ccie.net
>
> ______________________________________________________________________
> _ Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
Received on Wed Apr 17 2013 - 13:18:28 ART
This archive was generated by hypermail 2.2.0 : Wed May 01 2013 - 06:47:40 ART