Re: Disable port from STP

ok :-)

On 4/9/13, Marko Milivojevic <markom_at_ipexpert.com> wrote:
> "shutdown" :-)
>
>
> On Tue, Apr 9, 2013 at 4:04 AM, George Daly <george.daly_at_hotmail.com>
> wrote:
>
>> "no switchport" :)
>>
>> Cheers,
>> George
>>
>>
>> > Date: Tue, 9 Apr 2013 09:59:24 +0200
>> > Subject: Re: Disable port from STP
>> > From: krzysiek.zalewski_at_gmail.com
>> > To: immrccie_at_gmail.com
>> > CC: ccielab_at_groupstudy.com
>> >
>> > When I have below
>> >
>> > interface FastEthernet0/24
>> > switchport trunk encapsulation isl
>> > switchport trunk allowed vlan 2
>> > switchport mode trunk
>> > switchport nonegotiate
>> > spanning-tree portfast trunk
>> >
>> > SW1_H#sh spann vlan 2
>> >
>> > VLAN0002
>> > Spanning tree enabled protocol ieee
>> > Root ID Priority 32768
>> > Address 000f.cbfc.e81b
>> > Cost 19
>> > Port 25 (FastEthernet0/23)
>> > Hello Time 2 sec Max Age 20 sec Forward Delay 1 sec
>> >
>> > Bridge ID Priority 32770 (priority 32768 sys-id-ext 2)
>> > Address 001b.2b75.0d80
>> > Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec
>> > Aging Time 300
>> >
>> > Interface Role Sts Cost Prio.Nbr Type
>> > ------------------- ---- --- --------- --------
>> --------------------------------
>> > Fa0/1 Desg FWD 19 128.3 Shr
>> > Fa0/23 Root FWD 19 128.25 P2p
>> > Fa0/24 Desg FWD 19 128.26 P2p Edge <--- I see
>> > this port here
>> > Po23 Desg FWD 19 128.232 P2p
>> >
>> > - But when I will use flex-link or span session it will dissapear form
>> > above output.
>> > And the question is that maybe it is other configuration besides,
>> > flex and span when port will be removed from STP.
>> >
>> >
>> >
>> > On 4/9/13, Imran Ali <immrccie_at_gmail.com> wrote:
>> > > i am not sure if i got you question properly , portfast also
>> > > partially disables STP. it makes port skips listening and learning
>> states
>> > > and jump to forwarding state
>> > >
>> > >
>> > >
>> > >
>> > >
>> > > On Mon, Apr 8, 2013 at 3:30 PM, _ _ <krzysiek.zalewski_at_gmail.com>
>> wrote:
>> > >
>> > >> Hi.
>> > >> I have question about situation when port is disabled form STP.
>> > >> I know two options:
>> > >> > Flex link
>> > >> > Monitor session
>> > >> > Any other ideas?
>> > >> --
>> > >> Krzysiek
>> > >>
>> > >>
>> > >> Blogs and organic groups at http://www.ccie.net
>> > >>
>> > >>
>> _______________________________________________________________________
>> > >> Subscription information may be found at:
>> > >> http://www.groupstudy.com/list/CCIELab.html
>> > >>
>> > >>
>> > >>
>> > >>
>> > >>
>> > >>
>> > >>
>> > >>
>> > >
>> >
>> >
>> > --
>> > Krzysiek
>> >
>> >
>> > Blogs and organic groups at http://www.ccie.net
>> >
>> > _______________________________________________________________________
>> > Subscription information may be found at:
>> > http://www.groupstudy.com/list/CCIELab.html
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>>
>>
>>
>>
>>
>>
>>
>>
>

-- 
Krzysiek
Blogs and organic groups at http://www.ccie.net