Re: converting SIP to SCCP

Do you have some doc supporting this ?
AFAIK, the phone config specifies which load the phone has to have.
The phone checks if it has the correct one or else reconfigures itself,
infrastructure services (and cert validity) permitting.
Default for autoconfigured phones is set somewhere in the UCM config too.

-Carlos

Jason Aarons (AM) @ 26/02/2013 18:24 -0300 dixit:
> Whatever the last device load installed becomes default after installing them.
> So if SIP load was installed last it becomes the default. Re-install the load
> file for SCCPXX.XXXXXXX file and restart tftp
>
> From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of amin
> Sent: Saturday, February 23, 2013 7:06 AM
> To: ccielab_at_groupstudy.com
> Subject: converting SIP to SCCP
>
>
>
> Dear Experts,
>
>
>
> Converting SIP to SCCP, even the enterprise parameters for auto-registration
> is SCCP, and I delete the SIP phone, according to my knowledge it should
> re-register as SCCP phone 7940, but it insist to re-register as SIP on CUCM
> 8.6!!! any hits!!! Even if I make a factory reset sequence for the phone it
> still re-register as SIP
>
>
>
>
>
> Regards,
>
> Amin
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
> itevomcid
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>

-- 
Carlos G Mendioroz  <tron_at_huapi.ba.ar>  LW7 EQI  Argentina
Blogs and organic groups at http://www.ccie.net