Re: ospf virtual link authentication

Well, what happens if you don't use the first line? What were the results of your labbing it up?

How can you verify the authentication after configuring? What does it read a out the VL?

This could easily be a troubleshooting question, which is why I'm trying to get you to think more about the issue.

(Yes, you need both in your scenario below).

Regards,
Jay McMickle- CCIE #35355 (RS)
Sent from my iPhone 5

On Jan 11, 2013, at 10:31 AM, Tauseef Khan <tasneemjan_at_googlemail.com> wrote:

> Do i need both of the following commands for virtual link authentication or
> only the later one should be enough
>
> area 10 virtual-link 192.168.1.12 authentication message-digest
> area 10 virtual-link 192.168.1.12 message-digest-key 1 md5 cisco
>
> regards
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Fri Jan 11 2013 - 10:37:54 ART