Re: portfast default

following is the output from 3650 which says on all ports

SW1(config)#spanning-tree portfast default
%Warning: this command enables portfast by default on all interfaces. You
 should now disable portfast explicitly on switched ports leading to hubs,
 switches and bridges as they may create temporary bridging loops.

On 24 November 2012 15:03, Mohammad Mousa <mohd-mousa_at_hotmail.com> wrote:

>
> If you try to enable the portfast default command in the global
> configuration mode, you will see warning message says that all access ports
> will operate as portfast only!
>
> HTH
>
> --
> Mohammad Mousa
> CCIE #36990
>
>
> > Date: Sat, 24 Nov 2012 14:55:52 +0000
> > Subject: portfast default
> > From: tasneemjan_at_googlemail.com
> > To: ccielab_at_groupstudy.com
>
> >
> > If I have spanning-tree portfast default on switch will it effect the
> ports
> > in trunking mode too or would only effect the access ports. What effect
> > does it have on ports in dot1qtunnel mode.
> > Regards
> >
> >
> > Blogs and organic groups at http://www.ccie.net
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Sat Nov 24 2012 - 15:12:21 ART