Re: ASA problem

From: Tony Singh <mothafungla_at_gmail.com>
Date: Thu, 27 Sep 2012 07:34:36 +0100

Hi Jay

Thanks for reply yes it is the latter.

--
BR
Sent from my iPhone on 3
On 27 Sep 2012, at 02:02, Jay McMickle <jay.mcmickle_at_yahoo.com> wrote:
> Tony- how much RAM is in your 5505? If 256 (standard on old ones), this could be your issue with 8.3+ IOS.
> 
> If 512, disregard.
> 
> Regards,
> Jay McMickle- CCIE #35355 (RS), 3x CCNP (RS,Security,Design)
> Sent from my iPhone
> 
> On Sep 26, 2012, at 2:40 PM, Tony Singh <mothafungla_at_gmail.com> wrote:
> 
>> Hi Haroon
>> 
>> Next time it goes down will attempt your suggestion although it did have the
>> gateway of the last resort in the routing table :/
>> 
>> --
>> BR
>> 
>> Sent from my iPhone on 3
>> 
>> On 26 Sep 2012, at 20:27, Haroon <itguy.pro_at_gmail.com> wrote:
>> 
>>> what if you hard code default gateway?
>>> 
>>> route outside 0.0.0.0 0.0.0.0 isp
>>> 
>>> On Wed, Sep 26, 2012 at 1:27 PM, Tony Singh <mothafungla_at_gmail.com> wrote:
>>> Good Evening List,
>>> 
>>> I have an issue with my ASA 5505 recently seems to be locking up and
>>> end-result is no default gateway access to my isp router and bump no
>>> internet!
>>> 
>>> Its running Version 8.4(1)  & is a base license...
>>> 
>>> Now some t-shooting has got me no where, no top cpu-usage processes, enough
>>> free memory , asdm logs when it goes down nothing unusual but the usual pat
>>> translations with tcp flags i.e syn timeout etc etc..
>>> 
>>> translations showed...
>>> 
>>> *ciscoasa# show xlate count *
>>> 323 in use, 583 most used
>>> 
>>> tried clearing this - no good still could not ping my default gateway.....
>>> 
>>> an arp showed that I could see the default gateway address
>>> (although admittedly did not try clearing this to see if it did the arp
>>> translation again)
>>> 
>>> input packets from isp were stuck here, but might be down to above...
>>> 
>>> 
>>> ciscoasa(config-if)# sh int Vlan2
>>> Interface Vlan2 "outside", is up, line protocol is up
>>> Hardware is EtherSVI, BW 100 Mbps, DLY 100 usec
>>>       MAC address 001e.4a87.44ab, MTU 1500
>>>       IP address x.x.x.x, subnet mask 255.255.254.0
>>> Traffic Statistics for "outside":
>>>       *9747366 packets input*, 1919996429 bytes
>>>       14907915 packets output, 13057288639 bytes
>>>       760415 packets dropped
>>>     1 minute input rate 0 pkts/sec,  0 bytes/sec
>>>     1 minute output rate 8 pkts/sec,  464 bytes/sec
>>>     1 minute drop rate, 0 pkts/sec
>>>     5 minute input rate 0 pkts/sec,  2 bytes/sec
>>>     5 minute output rate 22 pkts/sec,  1297 bytes/sec
>>>     5 minute drop rate, 0 pkts/sec
>>> 
>>> ciscoasa(config-if)# sh int Vlan2
>>> Interface Vlan2 "outside", is up, line protocol is up
>>> Hardware is EtherSVI, BW 100 Mbps, DLY 100 usec
>>>       MAC address 001e.4a87.44ab, MTU 1500
>>>       IP address x.x.x.x, subnet mask 255.255.254.0
>>> Traffic Statistics for "outside":
>>>       *9747366 packets input*, 1919996429 bytes
>>>       14907919 packets output, 13057288877 bytes
>>>       760415 packets dropped
>>>     1 minute input rate 0 pkts/sec,  0 bytes/sec
>>>     1 minute output rate 8 pkts/sec,  464 bytes/sec
>>>     1 minute drop rate, 0 pkts/sec
>>>     5 minute input rate 0 pkts/sec,  2 bytes/sec
>>>     5 minute output rate 22 pkts/sec,  1297 bytes/sec
>>>     5 minute drop rate, 0 pkts/sec
>>> 
>>> 
>>> ciscoasa(config-if)# sh int Vlan2
>>> Interface Vlan2 "outside", is up, line protocol is up
>>> Hardware is EtherSVI, BW 100 Mbps, DLY 100 usec
>>>       MAC address 001e.4a87.44ab, MTU 1500
>>>       IP address x.x.x.x, subnet mask 255.255.254.0
>>> Traffic Statistics for "outside":
>>>       *9747366 packets input*, 1919996429 bytes
>>>       14907920 packets output, 13057288946 bytes
>>>       760415 packets dropped
>>>     1 minute input rate 0 pkts/sec,  0 bytes/sec
>>>     1 minute output rate 8 pkts/sec,  464 bytes/sec
>>>     1 minute drop rate, 0 pkts/sec
>>>     5 minute input rate 0 pkts/sec,  2 bytes/sec
>>>     5 minute output rate 22 pkts/sec,  1297 bytes/sec
>>>     5 minute drop rate, 0 pkts/sec
>>> 
>>> 
>>> 
>>> config on the outside interface is
>>> 
>>> interface Vlan2 (eth0/0)
>>> nameif outside
>>> security-level 0
>>> ip address dhcp setroute
>>> 
>>> 
>>> my outside interface picks up or still has the dhcpd binding from the isp
>>> and the outside svi vlan 2 pings from the asa ok...
>>> 
>>> been getting tired of reloading recently, so decided to shut the vlan 2 svi
>>> down and take the dhcp config off & re-applied this and it seemed to let me
>>> ping the default gateway again...
>>> 
>>> google dns 8.8.8.8 pings ok now, but xlates were showing 0 when attempting
>>> to connect from various devices and in the end had to reload the asa again.
>>> 
>>> apologies for this long mail, any suggestions on what im doing wrong
>>> 
>>> 
>>> Blogs and organic groups at http://www.ccie.net
>>> 
>>> _______________________________________________________________________
>>> Subscription information may be found at:
>>> http://www.groupstudy.com/list/CCIELab.html
>>> 
>>> 
>>> 
>>> 
>>> 
>>> 
>>> 
>>> 
>>> 
>>> 
>>> --
>>> Virtualization.net
>>> Post Jobs, News, Forums, Tutorials
>>> http://www.virtualization.net
>> 
>> 
>> Blogs and organic groups at http://www.ccie.net
>> 
>> _______________________________________________________________________
>> Subscription information may be found at: 
>> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
Received on Thu Sep 27 2012 - 07:34:36 ART

This archive was generated by hypermail 2.2.0 : Mon Oct 01 2012 - 06:40:29 ART