OSPF Point to Multipoint

Hi all,

I have a quick question, which might seem trivial to some of you but I can't answer it after reconfiguring several times and restarting OSPF processes.
I have FR hub and spoke topology, R5 is hub and R1 is a spoke.

I have configured DLCI's with the broadcast command for all spokes in the network (but we must transit through R5 obviously).
I have configured with "ip ospf network point-to-multipoint).

In this case, there should be no DR but on R1 I have the folioing output -

Rack14R1#show ip ospf neighbor

Neighbor ID Pri State Dead Time Address Interface
150.14.5.5 1 FULL/DR 00:01:44 155.14.0.5 Serial0/0

Rack14R5#show ip ospf neigh
Rack14R5#show ip ospf neighbor

Neighbor ID Pri State Dead Time Address Interface
150.14.4.4 0 FULL/ - 00:00:37 155.14.45.4 Serial0/1/0
150.14.1.1 0 FULL/ - 00:01:38 155.14.0.1 Serial0/0/0

HOWEVER, if we look at the LSA database we don't' see "Net Link State" for area 0. Which is LSA type 2 and would be originated by the DR.

Rack14R1#show ip ospf database | i (Area 0)
                Router Link States (Area 0)
                Summary Net Link States (Area 0)
                Summary ASB Link States (Area 0)

Did I just forget something? or am I right to expect Type 2 which I see state = FULL/DR ?

Thanks!

Shane
http://shanekillian.net

Blogs and organic groups at http://www.ccie.net
Received on Tue Jul 24 2012 - 20:40:25 ART