Re: Interworking in L2VPN

Can you post relevant configs and output
On May 14, 2012 6:00 AM, "CCIE KID" <eliteccie_at_gmail.com> wrote:

> Hi all
>
> I have a scenario where my Frame-Relay to Ethernet interworking is not
> working properly. Can someone tell me what are all the parameters to match
> when forming a T-LDP Pseudowire to be established between Ethernet one side
> of pseudowire and Frame Relay on the other side of Pseudowire.
> I know that there are certain parameters to match to make my Pseudowire
> T-LDP up
> The parameters are :
> 1.VC-ID
> 2.VC Type ( Port, VLAN, etc)
> 3.Interface MTU (AC)
> 4. LDP password
>
> But when u have interworking configured on both sides , Ur VC Type wont
> be matched on both the sides. In this cases, how will my T-LDP session will
> be up ?
>
> How will the Control plane signaling happens when there is a different VC
> types on both sides and i have configured my Interworking on both the
> sides.
>
> How will the router signal the other end of the peer to know which VC Type
> it is using and also the Interworking has been configured ?
>
> Is the use of Control Word comes into picture here ?
>
>
>
> --
> With Warmest Regards,
>
> CCIE KID
> CCIE#29992 (Security)
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Sun May 27 2012 - 09:44:28 ART