Re: Spoke-to-spoke multicast on multipoint FR

Sorry let me retract that statement about the nbma... :) too earlier in the morning. But I do hold to the IgP check this first make sure you van reach your RPs.

Regards,
 Joe Sanchez

On Mar 28, 2012, at 6:53 AM, Joe Sanchez <marco207p_at_gmail.com> wrote:

> Sameer, I do not believe that the nbma configuration is doing anything for you in the bSR setup as the BSR multicast packets will have the rp-candidate encapsulated inside the packets unlike auto-rp where the rp-announce is a separate packet.
>
> Go to each spoke and run (sh ip pim rp mapping) to ensure you are seeing the the correct RPs.
>
> Ensure you can ping the BSR ip address from your spokes. Multicast rides on top of you IGP so ensure you have full reachability.
>
>
> Regards,
> Joe Sanchez
>
> On Mar 28, 2012, at 5:09 AM, sameer khan <khanzadap_at_hotmail.com> wrote:
>
>> hey guys
>>
>> I am trying to configure spoke-to-spoke multicast on multipoint FR. i have
>> configured ip pim nbma on Hub but still not joy. For RP i am using BSR
>> configured on hub.
>> I can ping from hub-to-spoke but not spoke-to-spoke. can any one please shed
>> some light on it
>>
>> thanks
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Wed Mar 28 2012 - 07:16:07 ART