Re: Please confirm (conf#570d44f44fef15a38370d215e7d78f0e)

On 17 January 2012 16:36, Jitendra Anbu <jitanbu_at_gmail.com> wrote:

>
>
> On 17 January 2012 16:14, Cisco certification <ccielab_at_groupstudy.com>wrote:
>
>> Hi,
>>
>> You have tried to post to a GroupStudy.com certification mailing list.
>> Because
>> the server does not recognize you as a confirmed poster, you will be
>> required
>> to authenticate that you are using a valid e-mail address and are not a
>> spammer. By confirming this e-mail you certify that you are not sending
>> Unsolicited Bulk Email (UBE).
>>
>> PLEASE DO NOT SEND YOUR ORIGINAL MESSAGE AGAIN! BY CONFIRMING THIS EMAIL
>> YOUR ORIGINAL MESSAGE (WHICH IS NOW QUEUED IN THE SERVER) WILL BE POSTED.
>>
>>
>> By confirming this e-mail you also certify the following:
>>
>> 1. The message does NOT break Cisco's Non-Disclosure requirements.
>>
>> 2. The message is NOT designed to advertise a commercial product.
>>
>> 3. You understand all postings become property of GroupStudy.com
>>
>> 4. You have searched the archives prior to posting.
>>
>> 5. The message is NOT inflammatory.
>>
>> 6. The message is NOT a test message.
>>
>> To confirm, simply reply to this message. No editing is necessary. Once
>> confirmed, you will be able to post without additional confirmations.
>>
>>
>> Welcome to GroupStudy.com!
>>
>>
>> First time posters to GroupStudy.com are required to agree to the
>> GroupStudy terms and conditions.
>> Replying to this email, certifies you have read and agree to the
>> GroupStudy posting guidelines and terms and conditions.
>>
>> --- Original Message Follows ---
>>
>> Date: Tue, 17 Jan 2012 16:14:00 +1100
>> Subject: Port-channels with sub-interfaces on ASR1002..
>> From: Jitendra Anbu <jitanbu_at_gmail.com>
>> To: ccielab_at_groupstudy.com
>>
>> Hello all, I am wondering if someone could advice why I am not able to
>> configure a port-channel with sub-interfaces connecting to multiple Cisco
>> 3750, as shown bellow - work correctly.
>>
>>
>> **************
>> *** ASR ****
>> **************
>> | |
>> | |
>> | |
>> SW1 |
>> |
>> SW2
>>
>> I've found that the ASR 1k series only do LACP. Therefore the config on
>> the
>> two 3750s were done accordingly.
>>
>> I have the following config on the devices;
>>
>> -------------------- ASR -------------------------
>>
>> conf t
>> interface port-channel 1
>> no ip address
>>
>> interface port-channel 1.5
>> encapsulation dot1Q 5
>> ip address 10.1.1.1 255.255.255.0
>> exit
>> !
>> int gi0/2/2
>> channel-group 1
>> no shu
>>
>> !
>> int gi0/3/2
>> channel-group 1
>> no shu
>>
>>
>> --------------- SW1 ------------------------
>> vlan 5
>> name test5
>> exit
>> !
>>
>> interface GigabitEthernet1/0/49
>> switchport trunk encapsulation dot1q
>> switchport mode trunk
>>
>> (Original message truncated)

Blogs and organic groups at http://www.ccie.net
Received on Tue Jan 17 2012 - 16:36:36 ART