OER Active Probes

Can anyone tell me why when I issue the "show oer master active-probes" or
"show oer border active-probes" command I see nothing? Below is my master
config, border is just the OER basics...

oer master
 policy-rules OER
 logging
 !
 border 19.19.2.2 key-chain OER
  interface Serial0/0 external
  interface FastEthernet0/1 external
  interface FastEthernet0/0 internal
 no max range receive
 mode route control
 mode select-exit best
!
!
!
oer-map OER 1
 match traffic-class prefix-list THREE3
 set loss threshold 10
 set active-probe echo 19.19.33.3
 set probe frequency 4
!
oer-map OER 2
 match traffic-class prefix-list THREE0
 set loss threshold 10
 set active-probe echo 19.19.30.3
 set probe frequency 4
!

-- 
Steven M. Blasiol
Blogs and organic groups at http://www.ccie.net