Re: Need help on Catalyst 6509E

Can you issue a " dir all" command in there and paste the ouput...most
likely you have a crashfile in there that will tell us why it reloaded due
to bus error ...it does not necessarily mean its a HW issue.

Hash

On Tue, Aug 9, 2011 at 7:00 AM, <want2bccie_at_gmail.com> wrote:

> Hi Abdul,
>
> Yesterday I faced same issue with 6506 it was rebooting of its own , later
> found issue with one on the line card.
>
> Don't know what it could be in yours case but try removing line cards and
> boot with only SUP module inserted. And later try with other modules one bt
> one.
>
> Regards,
> Nash
> Sent on my BlackBerry. from Vodafone
>
> -----Original Message-----
> From: garry baker <baker.garry_at_gmail.com>
> Sender: nobody_at_groupstudy.com
> Date: Tue, 9 Aug 2011 00:23:32
> To: Abdul Muhammed<abdulmuri_at_gmail.com>
> Reply-To: garry baker <baker.garry_at_gmail.com>
> Cc: Cisco certification<ccielab_at_groupstudy.com>
> Subject: Re: Need help on Catalyst 6509E
>
> best thing to do is contact TAC with this kind of error...
>
> short of that if you do not have support, then start with these docs:
>
>
> http://www.cisco.com/en/US/products/sw/iosswrel/ps1831/products_tech_note09186a00800cdd51.shtml
>
> https://supportforums.cisco.com/thread/2051037
>
>
> http://www.cisco.com/en/US/products/hw/switches/ps708/products_tech_note09186a008072c406.shtml
>
> or start removing modules down the the SUP and see if it is stable and/or
> start upgrading code to the highest leve that will support your
> chasiss/fan/sup/line cards...
>
>
> --
> Garry L. Baker
>
> "With sufficient thrust, pigs fly just fine..." - RFC 1925
>
>
>
> On Tue, Aug 9, 2011 at 12:03 AM, Abdul Muhammed <abdulmuri_at_gmail.com>
> wrote:
>
> > Hi all,
> >
> > I have problem with our newly 6509E. it keeps reloading to a Rom mode
> > and when I use reset command it starts by loading the bootstrap below
> > System Bootstrap, Version 12.2(17r)SX5, RELEASE SOFTWARE (fc1)
> > and hang. when i power off and power on, it start by loading as below
> and
> > boot normally.
> > System Bootstrap, Version 8.5(3)
> > Copyright (c) 19 94-20 08 by cisco Systems, Inc.
> > Cat6k-Sup720/SP processor with 524288 Kbytes of main memory
> >
> > Autoboot executing command: "boot
> > bootflash:s72033-adventerprise_wan-mz.122-33.SXI7.bin"
> > Loading image, please wait ...
> > after full loading of the IOS the below command shows that all the
> modules
> > are ok
> >
> > Core-Switch#sh module
> > Mod Ports Card Type Model
> Serial
> > No.
> > --- ----- -------------------------------------- ------------------
> > -----------
> > 3 48 CEF720 48 port 1000mb SFP WS-X6748-SFP
> > SAL13495TES
> > 6 2 Supervisor Engine 720 (Active) WS-SUP720-3B
> > SAL13400AD9
> > 8 10 WiSM WLAN Service Module WS-SVC-WISM-1-K9
> > SAD141003UX
> > Mod MAC addresses Hw Fw Sw
> > Status
> > --- ---------------------------------- ------ ------------ ------------
> > -------
> > 3 588d.09c1.20f4 to 588d.09c1.2123 2.4 12.2(18r)S1 12.2(33)SXI7 Ok
> > 6 001f.6c77.68e4 to 001f.6c77.68e7 5.9 8.5(3) 12.2(33)SXI7 Ok
> > 8 68ef.bd30.e030 to 68ef.bd30.e03f 2.4 12.2(14r)S5 12.2(33)SXI7 Ok
> > Mod Sub-Module Model Serial Hw
> > Status
> > ---- --------------------------- ------------------ ----------- -------
> > -------
> > 3 Centralized Forwarding Card WS-F6700-CFC SAL13495NAM 4.1 Ok
> > 6 Policy Feature Card 3 WS-F6K-PFC3B SAL1340047H 2.6 Ok
> > 6 MSFC3 Daughterboard WS-SUP720 SAL13400BQE 4.0 Ok
> > 8 Centralized Forwarding Card WS-SVC-WISM-1-K9-D SAD1411000Z 2.2 Ok
> > Mod Online Diag Status
> > ---- -------------------
> > 3 Pass
> > 6 Pass
> > 8 Pass
> > The show Bootvar and remote command switch sh bootvar shows different
> > location for the boot variable as below
> > and have set the boot option to boot system flash
> > sup-bootdisk:s72033-adventerprise_wan-mz.122-33.SXI7.bin
> > Core-Switch#sh bootvar
> > BOOT variable =
> sup-bootdisk:s72033-adventerprise_wan-mz.122-33.SXI7.bin,1;
> > CONFIG_FILE variable does not exist
> > BOOTLDR variable =
> > Configuration register is 0x2102
> > Standby not ready to show bootvar
> > Core-Switch#remote command switch sh bootvar
> > BOOT variable = bootdisk:s72033-adventerprise_wan-mz.122-33.SXI7.bin,1;
> > CONFIG_FILE variable does not exist
> > BOOTLDR variable =
> > Configuration register is 0x2102
> >
> > The shoe version shows that the Last reload reason: bus error at PC
> > 0x428549D8, address 0x0
> > Core-Switch#sh ver
> > Cisco IOS Software, s72033_rp Software (s72033_rp-ADVENTERPRISE_WAN-M),
> > Version 12.2(33)SXI7, RELEASE SOFTWARE (fc1)
> > Technical Support: http://www.cisco.com/techsupport
> > Copyright (c) 1986-2011 by Cisco Systems, Inc.
> > Compiled Mon 18-Jul-11 05:49 by prod_rel_team
> > ROM: System Bootstrap, Version 12.2(17r)SX5, RELEASE SOFTWARE (fc1)
> > Core-Switch uptime is 3 minutes
> > Uptime for this control processor is 4 minutes
> > Time since Core-Switch switched to active is 3 minutes
> > System returned to ROM by power cycle at 05:08:49 UTC Mon Aug 8 2011 (SP
> > by
> > power on)
> > System image file is
> > "sup-bootdisk:s72033-adventerprise_wan-mz.122-33.SXI7.bin"
> > Last reload reason: bus error at PC 0x428549D8, address 0x0
> >
> > cisco WS-C6509-E (R7000) processor (revision 1.5) with 458720K/65536K
> bytes
> > of memory.
> > Processor board ID SMC1503002G
> > SR71000 CPU at 600Mhz, Implementation 0x504, Rev 1.2, 512KB L2 Cache
> > Last reset from s/w reset
> > 9 Virtual Ethernet interfaces
> > 60 Gigabit Ethernet interfaces
> > 1917K bytes of non-volatile configuration memory.
> > 8192K bytes of packet buffer memory.
> > 65536K bytes of Flash internal SIMM (Sector size 512K).
> > Configuration register is 0x2102
> >
> > Thanks
> >
> > --
> > Cherish your visions and your dreams as they are the children of your
> soul,
> > the blueprints of your ultimate achievements. "Napoleon Hill"
> >
> > There are no limitations to the mind except those we acknowledge; both
> > poverty and riches are the offspring of thought. "Napoleon Hill"
> >
> > Abdul Muhammed Murtala
> > American University of Nigeria
> > Lamido Zubairu way, Yola
> > Adamawa
> > +2348052001153, +2348056201237
> >
> > Network Manager
> > MCSE,MCDBA,MCSA,OCPDBA,CCNA,CCIE Written.
> >
> >
> > Blogs and organic groups at http://www.ccie.net
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Wed Aug 10 2011 - 00:23:11 ART