Re: Multicast with HSRP.

Try setting your DR priority. I ran into a similar issue where my
secondary HSRP was being elected the DR for the segment since it had a
higher IP address. Once I set the DR to the primary hsrp switch all
was well. This should still fail over fine as well.

-Marc

On Tue, Jul 26, 2011 at 5:18 PM, JB Poplawski <jb.poplawski_at_gmail.com> wrote:
> Good afternoon,
>
> I'm currently running into a random multicast issue. We have a
> connection to a vendor sending us multicast feeds. I have static
> routes to the source ips to their HSRP address for RPF purposes. My
> host subscribes and I can see (with show ip mroute) the groups show
> up, but no data. Figuring it was an HSRP issue, I added a static
> M-Route to one of the physical host IPs and BAM!!! starting receiving
> traffic.
>
> http://www.cisco.com/en/US/tech/tk828/technologies_tech_note09186a0080094aab.shtml
>
> Where's my goof? I add the static m-route to the HSRP address it
> stops, re-add to a physical and it works again. My concern is if I
> add a default static m-route to a physical device and that host dies,
> I have to hurry quick and change the default m-route.
>
> Topology is basically the same as attached cisco document.
>
> Any thoughts or creating solutions?
> JB
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Tue Jul 26 2011 - 18:04:27 ART