Re: Source IPv6 and Destination IPv4 can we perform routing in

In addition to what others have said, you might want to specifically read up
on NAT-PT

On Tue, Jul 12, 2011 at 8:34 AM, Scott Morris <swm_at_emanon.com> wrote:

> Well, and Ipv6 packet will never have an IPv4 address as the destination
> natively, so that may answer the first part of your question.
>
> Because someplace along the way, you'll need to tell the source about
> SOME address to use as the IPv6 destination.
>
> If your destination really is an IPv4 host, then again, someplace along
> the way, there will need to be a change (NAT) between the v6 information
> and the v4 information.
>
> HTH,
>
> Scott Morris, CCIEx4 (R&S/ISP-Dial/Security/Service Provider) #4713,
>
> CCDE #2009::D, JNCIE-M #153, JNCIE-ER #102, CISSP, et al.
>
> CCSI #21903, JNCI-M, JNCI-ER
>
> swm_at_emanon.com
>
> Knowledge is power.
>
> Power corrupts.
>
> Study hard and be Eeeeviiiil......
>
> On 7/12/11 1:55 AM, Prakash Kalsaria wrote:
>
> Hi all
>
> I like to have some idea
> if Source is IPv6 and I other end i have to IPv4 (destination) for
> routing
> can i acheive this With any means
>
> Regards Prakash Kalsaria
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>

-- 
Regards,
Joe Astorino
CCIE #24347
Blog: http://astorinonetworks.com
"He not busy being born is busy dying" - Dylan
Blogs and organic groups at http://www.ccie.net