RE: Cross connect between two serial interfaces

Thanks Marc; Is the below enough to make HDLC work or i'm missing something,
as the below doesn't work :), And R1 not able to ping R2 R3#sh run | in
bridge
bridge irb
 bridge-group 1<<<<<Under ser 0/0
 bridge-group 1<<<<<Under ser 0/1
bridge 1 protocol ieee
bridge 1 route ip
> Date: Sun, 19 Jun 2011 10:01:23 -0500
> Subject: Re: Cross connect between two serial interfaces
> From: marcabel_at_gmail.com
> To: mohamed_kamar_at_hotmail.com
> CC: ccielab_at_groupstudy.com
>
> Or if there is no requirement to keep the PPP, then could disable it
> and run HDLC. Then you could bridge it.
>
> On Sun, Jun 19, 2011 at 9:54 AM, mohamed kamar
> <mohamed_kamar_at_hotmail.com> wrote:
> > Thanks Marc;
> > The problem is that the end customer doesn't want to configure
> > virtual-template in his ends (R1 and R2), And he needs that all
> > configuration to be done in his serial interface as if they are
> > back-to-back. Not sure we can do this for him, Or we can say the only
> > solution is PPPoFR and to use virtual-template in his ends, Thanks again
> >
> >> Date: Sun, 19 Jun 2011 09:33:43 -0500
> >> Subject: Re: Cross connect between two serial interfaces
> >> From: marcabel_at_gmail.com
> >> To: mohamed_kamar_at_hotmail.com
> >> CC: ccielab_at_groupstudy.com
> >>
> >> I was going to say bridging but I believe that requires either HDLC or
> >> Frame-relay on the serial links. Could you run back to back frame
> >> relay underneath your PPP?
> >>
> >> On Sun, Jun 19, 2011 at 9:16 AM, mohamed kamar
> >> <mohamed_kamar_at_hotmail.com> wrote:
> >> > Dear All; My question could be easy but i don't know it's answer :)
> >> > (R1)S0/0----------S0/0(R3)S0/1-----------S0/0(R2) |
> >> > | -------------------------ppp------------------------- How can i
cross
> >> > connect in R3 between S0/1 and S0/0 to run PPP between R1 and R2 on
its
> >> > serial
> >> > interfaces directly without involving R3 in any L3 ip addressing or
> >> > routing
> >> > protocol, thanks
> >> >
> >> >
> >> > Blogs and organic groups at http://www.ccie.net
> >> >
> >> >
Received on Sun Jun 19 2011 - 15:07:05 ART