RE: OT`: 3750v2 stack

Dear

Try to do these steps.

        1 Using a console cable, select a master switch and build a base
 configuration that will be used for the entire switch stack. For the
slave switches, use the "write erase" and "delete flash:vlan.dat"
commands to clear the previous configuration.

        2 Provision the master switch using the "switch 1 provision
ws-c3750-##"
 command in global configuration mode; adjust the command for your
specific hardware. Repeat the command to provision switch 2, switch
3, etc.

        3 Set the master switch priority highest using the "switch 1 priority
15" command in global configuration mode.

        4 Connect the Cisco StackWise cables diagonally from Switch 1 to
 Switch 2, from Switch 2 to Switch 3, etc. Then, cable the top-most
switch to the bottom master switch (if starting from bottom).

        5.Verify that provisioning was successful using the command "show
switch detail."

and tell us its working or not

> Date: Fri, 10 Jun 2011 20:34:22 +0200
> Subject: OT`: 3750v2 stack
> From: mr.vervoorn_at_gmail.com
> To: ccielab_at_groupstudy.com
>
> Hi group,
>
> Does anyone have any experience with issue stacking a cisco the 3750v2 and
> normal 3750 switch. I have a stack of 3 switches. The v2 switch configured
> with the lowest priority so it should be switch 3 in the stack but it comes
> in the stack as switch 2 and the other switch is disapeared from the stack
>
> thanks in advance
>
> Maarten
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Sat Jun 11 2011 - 22:59:52 ART