Sample Task: Configure SW3 interface fa0/4 in VLAN 3.
My Solution Config:
interface fa0/4
switchport mode access
switchport access vlan 3
Can the "extra" step of switchport mode access hurt me? No. Could it help me
gain points? Yes. Therefore, I go for it in the lab exam.
Here is an article where I expand upon this line of question....
http://blog.ipexpert.com/2011/03/22/am-i-penalized-for-over-configuration-in
-the-lab/
-----Original Message-----
From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
Stephen Robinson
Sent: Friday, June 03, 2011 1:59 PM
To: group-study
Subject: Switch mode access
In the lab. Should access ports be hard coded as access?
If the task assigned does not specifically say to put the switches ports in
'mode access' do you think it should be done as a best practice? Or do you
think Cisco would see that as a wrong answer?
Blogs and organic groups at http://www.ccie.net
Received on Fri Jun 03 2011 - 14:16:44 ART
This archive was generated by hypermail 2.2.0 : Fri Jul 01 2011 - 06:24:27 ART