Re: MPLS Question

> Hi all,
>
> Thanks.
>
> After running through cisco documents, i have run into the common issue as
> below link.
>
>
> http://www.cisco.com/en/US/tech/tk436/tk428/technologies_tech_note09186a0080144ab2.shtml
>

>
>
> On Tue, Feb 22, 2011 at 9:30 PM, Tyson Scott <tscott_at_ipexpert.com> wrote:
>
>> If you have a hub and spoke topology and are running MPLS you must use
>> multipoint network type. Please expand on your configuration.
>>
>>
>> -----Original Message-----
>> From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
>> Maarten Vervoorn
>> Sent: Tuesday, February 22, 2011 8:12 AM
>> To: Vincent Tay
>> Cc: Ccielab_at_groupstudy.com
>> Subject: Re: MPLS Question
>>
>> MPLS LDP is supportig that. I think there was an issue in you OSPF
>> configuration, Could you reconfigure the network with point-to-multipoin
>> and
>> post your configurations. Check if your OSPF neighbors are up check if
>> your
>> ldp router-id's are propagated
>>
>> Kind regards,
>>
>> Maarten Vervoorn
>>
>>
>>
>> 2011/2/22 Vincent Tay <vtay.75_at_gmail.com>
>>
>> > Hi all,
>> >
>> > Can anyone point me to Cisco resources or explain why and is it true
>> that
>> > ip
>> > ospf network point-to-multipoint does not support MPLS LDP. I have try
>> > to lab it and MPLS does not tag until it was change to ip ospf network
>> > broadcast in the frame relay cloud. Thanks.
>> >
>> > Regards
>> > Vincent Tay
>> >
>> >
>> > Blogs and organic groups at http://www.ccie.net
>> >
>> > _______________________________________________________________________
>> > Subscription information may be found at:
>> > http://www.groupstudy.com/list/CCIELab.html
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Wed Feb 23 2011 - 20:35:53 ART