Re: Simple MPLS : Difference between "untagged" and "pop tag"

Hi Carlos,

Yes I do know the difference, explicit-null will still put a null (0) label.

I just remembered for some reason that in a show command: "show mpls
forwarding-table" that showed up as "Untagged" too,

I was wrong! :)

On Sun, Dec 26, 2010 at 8:22 PM, Carlos G Mendioroz <tron_at_huapi.ba.ar>wrote:

> Hmm, no.
> Explicit-null would actually use the null (0) tag on the last MPLS hop.
> Explicit-null will just show as 0, AFAIK.
>
> -Carlos
>
> George Goglidze wrote:
>
>> I can't check it right now, but I think "explicit-null" label would
>> indicate "Untagged" as well in the LFIB.
>> Please correct me if I'm wrong.
>>
>> Regards,
>>
>> On Sun, Dec 26, 2010 at 2:05 PM, Carlos G Mendioroz <tron_at_huapi.ba.ar<mailto:
>> tron_at_huapi.ba.ar>> wrote:
>>
>> Pop tag means that the destination (network) is connected to a LSR,
>> i.e., a router that this router knows that supports MPLS.
>> This may be because he is receiving LDP from it indicating
>> "implicit-null" as the tag for this prefix.
>>
>> Untagged means that the destination is known by some means (routing
>> protocol?) but the next hop is not MPLS aware (this router is not
>> receiving MPLS tag info for this prefix) so it will remove the stack
>> before forwarding.
>>
>> In your example, the 11.1.68.0/24 <http://11.1.68.0/24> is locally
>>
>> connected, and the "next hop" is this router itself.
>> The 11.1.6.6/32 <http://11.1.6.6/32> is connected to another router
>>
>> and there is no tag info
>> for this prefix. May be the loopback is a /24 ?
>>
>> -Carlos
>>
>>
>> Manouchehr Omari wrote:
>>
>> Pop tag means remove the top label and send the remaining payload.
>> Untagged means the outgoing interface is not MPLS enabled remove
>> the label
>> and send the packet without label.
>>
>> I recommend you to read "MPLS Fundamentals" which cover these
>> tips in
>> detail.
>>
>> HTH
>>
>>
>> On Sat, Dec 25, 2010 at 9:33 PM, Lefe Meedorf
>> <feeldefreedom_at_gmail.com <mailto:feeldefreedom_at_gmail.com>>wrote:
>>
>>
>> Hi,
>>
>> In my simple MPLS setup, I see following entires in "LFIB".
>>
>> R5#show mpls forwarding-table
>> Local Outgoing Prefix Bytes tag Outgoing
>> Next Hop
>> tag tag or VC or Tunnel Id switched interface
>> 16 Untagged 11.1.6.6/32 <http://11.1.6.6/32> 0
>> Se0/0 point2point
>> 17 Pop tag 11.1.68.0/24 <http://11.1.68.0/24> 0
>>
>> Se0/0 point2point
>>
>> What is the difference between "Untagged" and "Pop tag" ?
>> 11.1.6.6 is R6 (i.e. PE) Loopback 0.
>> 11.1.68.0/24 <http://11.1.68.0/24> is network between R6 and
>>
>> CE router.
>>
>> Topology
>> ---(R5)----(R6)----(CE)
>>
>> R6 Lo : 11.1.6.6/32 <http://11.1.6.6/32>
>> R6/CE : 11.1.68.0/24 <http://11.1.68.0/24>
>>
>>
>> --
>> /Lefe Meedorf/
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>>
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>>
>>
>>
>>
>>
>>
>>
>>
>> -- Carlos G Mendioroz <tron_at_huapi.ba.ar <mailto:tron_at_huapi.ba.ar
>> >>
>>
>> LW7 EQI Argentina
>>
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>>
>>
>>
>>
>>
>>
>>
>>
>>
> --
> Carlos G Mendioroz <tron_at_huapi.ba.ar> LW7 EQI Argentina

Blogs and organic groups at http://www.ccie.net
Received on Sun Dec 26 2010 - 22:39:39 ART