Re: EIGRP Doubt

Hello,

It also works in eigrp. And your config is just fine, but you
have a small typo in your distance command.

You are defining access-list 1 and you are using access-list 2
in your distance command.

Regards,
Rares

On Tue, Dec 21, 2010 at 5:39 PM, HEMANTH RAJ <hemanthrj_at_gmail.com> wrote:

> Hey guys a small doubt in eigrp distance command
> Can we specify distance command for a particular prefix like in rip
>
> i tried a example but its not working
>
> access-list 1 permit 2 2.2.0 0.0.0.255
>
> router eigrp 100
> distance 100 20.1.1.1 0.0.0.0 2
>
> So the source is 20.1.1.1 and the network is 2.2.2.0/24 For this prefix
> from
> this neighbour it must set a distance of 100
> but it is not working in eigrp
> i tried in rip
> it is working perfectly
>
> Can anyone tell me can we assign a AD for a particular prefix in eigrp
>
>
>
> --
> Problems arise because we talk,problems are not solved because we don't
> talk
> So good or bad talk to your affectionate one's freely.
>
> Yours Friendly,
> HP HEMANTH RAJ
> Cisco Systems Inc.
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Tue Dec 21 2010 - 17:49:31 ART