Re: MA on spoke router !! Rp on another spoke !! sender/receier

From: imran ali <immrccie_at_gmail.com>
Date: Wed, 8 Dec 2010 15:43:04 +0300

thanks Anthony,

ip pim nbma mode command should technically inject other spokes in OIL list
.

i have seen brain tricking a solution as follows

on spoke / hub configure static rp with access list that permits 224.0.1.39
and 224.0.1.40
so that hub can treat these two groups as sparse . so hub should forward
traffic out to every spoke
as present in OIL

theoretically logical when tested on gns3 , no success .

Regards
On Wed, Dec 8, 2010 at 1:14 PM, Anthony Sequeira <asequeira_at_ine.com> wrote:

> I believe that tunneling would have to be used in a situation like this.
>
> The Auto-RP mapping agent on a spoke device in a Frame hub and spoke
> environment has issues, and as such, the R&S Lab Exam would not have us
> configure this, unless they permitted some very big "workarounds".
>
> -----Original Message-----
> From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
> imran ali
> Sent: Tuesday, December 07, 2010 5:12 PM
> To: Cisco certification
> Subject: MA on spoke router !! Rp on another spoke !! sender/receier on
> another spoke ...
>
> hi experts ,
>
> if in a lab environment the task ask to configure MA on a spoke router
> which dont have direct l2 circuits with others except the Hub , the other
> spokes will not get mappings due to lack of l2 connectivity . what are
> different work around we can have ???
>
> i m getting a lot of frustration after trying hard to get a successful ping
> from a spoke routers.
>
> R1 is a hub R2 , R3 , R4 are spokes . R2 is RP and R3 is MA , the
> receivers are behind R4 . All running pim sparse mode , no rpf issues as
> topology is very simple running single igp and pim on all interface (each
> router has only one s0/0 int connected to cloud )
>
> however R4 is not getting MA messages and ping fails . i have given ip pim
> nbma mode / auto rp listener command on the hub router as well.
>
> has any one tried multi casting heavily on dynamips and spotted any issues
> ?
>
>
> Regards
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Wed Dec 08 2010 - 15:43:04 ART

This archive was generated by hypermail 2.2.0 : Sat Jan 01 2011 - 09:37:49 ART