Re: ipv6 multicast testing

R4(config-if)#ipv6 mld join-group FF02::224:1:1:1

R4(config-if)#do sh ipv6 int
Loopback0 is up, line protocol is up
  IPv6 is enabled, link-local address is FE80::C606:24FF:FE44:0
  No Virtual link-local address(es):
  Global unicast address(es):
    2001::C606:24FF:FE44:0, subnet is 2001::/64 [EUI]
  Joined group address(es):
    FF02::1
    FF02::2
    FF02::1:FF44:0
    FF02::224:1:1:1
  MTU is 1514 bytes
  ICMP error messages limited to one every 100 milliseconds
  ICMP redirects are enabled
  ICMP unreachables are sent
  ND DAD is not supported
  ND reachable time is 30000 milliseconds
  Hosts use stateless autoconfig for addresses.

R4#sh ipv6 mld interface loopback 0
Loopback0 is up, line protocol is up
  Internet address is FE80::C606:24FF:FE44:0/10
  MLD is disabled on interface

R4#ping FF02::224:1:1:1
Output Interface: Loopback0
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to FF02::224:1:1:1, timeout is 2 seconds:
Packet sent with a source address of FE80::C606:24FF:FE44:0

Reply to request 0 received from FE80::C606:24FF:FE44:0, 4 ms
Reply to request 1 received from FE80::C606:24FF:FE44:0, 4 ms
Reply to request 2 received from FE80::C606:24FF:FE44:0, 4 ms
Reply to request 3 received from FE80::C606:24FF:FE44:0, 4 ms
Reply to request 4 received from FE80::C606:24FF:FE44:0, 0 ms
Success rate is 100 percent (5/5), round-trip min/avg/max = 0/3/4 ms
5 multicast replies and 0 errors.

--
Garry L. Baker
"There is no 'patch' for stupidity." - www.sqlsecurity.com
2010/11/30 gp <gs4me2me_at_gmail.com>
>  That is for emulate host, but how to emulate server?
>
>
>
>
>
> *From:* garry baker [mailto:baker.garry_at_gmail.com]
> *Sent:* Tuesday, November 30, 2010 5:46 PM
> *To:* gp
> *Cc:* ccielab_at_groupstudy.com
> *Subject:* Re: ipv6 multicast testing
>
>
>
> 'ipv6 mld join-group'
>
> mld "is" igmp for ipv6
>
>
> --
> Garry L. Baker
>
> "There is no 'patch' for stupidity." - www.sqlsecurity.com
>
>  On Tue, Nov 30, 2010 at 10:22 AM, gp <gs4me2me_at_gmail.com> wrote:
>
> Hi all,
>
>
>
> How to test ipv6 multicast on routers, like for ipv4 on router to emulate
> server with ping 224.1.1.1 and to emulate the host with ip igmp join group
> 224.1.1.1.
>
> Is it possible something like this for ipv6?
>
>
>
> Thanks
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net